As is known to all, a piece of synchronous belt transmission is basic need at least a dozen of hours each day, some big enterprises and even never stopped, no matter how good the quality of the synchronous belt, the loss is very big, this is inevitable. So the assembly of synchronous belt is one of the workshop teacher must grasp the knowledge, relative to some family workshop equipment replacement, here can teach you some attention to the point. 1, before installation on the synchronous belt, during which the application of the equipment must be used to stop operation and cut off the power supply, because in the case of not to cut off the power supply is easy to cause damage to the machine, or their own personal safety is threatened, on the other hand, if the gear on the protective measures of protection, need to remove the protective device first, after the removal of motor. 。 2, in the removal of gear motor after the original old synchronous belt can easily take down, but there will be a situation is, producers may in order to make the synchronous belt more solid could use super glue attached on the equipment, then you need to use loose tools for processing and then forced demolition, powerful dismantle here refers to the premise of no equipment damage. 3, the most important thing is the equipment of the synchronous belt type must be and equipment requirements, otherwise will like wore the big shoes on the feet, can affect not only beautiful and also can make the equipment can't run well. Here, you will need before installation in confirm the models match to ensure the safe, when it's necessary for cleaning, remove dirt from the transport. 。