Synchronous belt as a driving part, because has been widely used in our daily life, so people are very deep understanding of it. But because of the limitation of thinking, people do little on synchronous belt protection work, and some consumers to the protection of synchronous belt is wrong, so how to protect consumers synchronous belt. For synchronous belt protection in the first place, just need to know the difference between the protection and use of protection and placed, there is a big difference between the protection of the consumer protection is important to note. Because only use the right protection, can protect the synchronous belt, if you use the wrong way, so not only failed to protect the effect also can destroy the synchronous belt, so the protection of synchronous belt need how? Synchronous belt wheel is driven synchronous belt, the function of transmission equipment. Users in the use of synchronous belt wheel, or in the preservation, need to be careful to caress it, in order to prolong the service life of synchronous belt wheel. Synchronous belt wheel when not using, the user needs to keep in a cool place, don't be exposed to the sun. Synchronous belt wheel cannot be stored in a humid environment, some of the parts will be affected by the moisture, rust or is the expansion and deformation. In the store it, users will bring tooth synchronous wipe clean, so as to avoid accumulation in seam stains will its surface corrosion. Synchronous belt and synchronous wheel to install and use the matters needing attention, reduce the number of belt wheel center distance, if there is a tension wheel should be loosened, mount tape again after adjusting the center distance. For fixed transmission center distance, should first remove the pulley, the belt again after loaded on the belt wheel fixed on put pulley to the shaft. Synchronous belt wheel at the time of use, will bring the synchronous gear and synchronous belt tooth completely fit, need to adjust the before each use, driving wheel and driven wheel spindle must keep on the parallel degree of tangent tg = 1/1000. Shaft is not accurate, is will directly lead to the life of the synchronous belt wheel. When the user found the belt on the driving wheel offset to one side, you need to move the passive wheel, adjust the pressure of tight round. At the same point of operation, the user must not allow solid fall into the tooth socket, so usually pay attention to the work environment clean.