Manually open the entrance door of the formation slot, and then use photoelectricity to control the cylinders of the pattern conveyor belt, counting 6 and single control. After the battery is in place, the cylinder of the conveyor line will push the battery into the road and start the conveyor belt to run 400mm, the conveyor belt stops, and the cylinder returns to the same position. Repeat this to complete the slot. (Manual) Close the entrance door. Adjust the liquid level sensor to ensure the water level required for any battery size, inject cooling water, and circulate. There is an acid meter to monitor the pH of the tank water at any time, control the caustic soda solution into the tank, and ensure that the cooling water has a neutral pH. The formation of the battery is completed and the tank is out: the cooling water is discharged. Lift the exit gate (manual) of the formation tank, the water level is controlled at 3mm on the lower surface of the conveyor belt to ensure water lubrication. The following items should be noted in the use of the pattern conveyor belt: ① Avoid the roller covered by the material, causing the rotation to fail, prevent the leakage of material from being caught between the roller and the tape, pay attention to the lubrication of the moving part, but do not allow the oil conveyor belt to be contaminated; ② Avoid starting with load; ③The deviation of the conveyor belt occurs, take measures to correct it when applying; ④ When the conveyor belt is found to be partially damaged, it should be repaired to avoid expansion.