Double synchronous belt in the process of installation maintenance degree double synchronous belt installation note: reduce the number of belt wheel center distance, if there is a tension wheel should be loosened, mount tape again after adjusting the center distance. For fixed transmission center distance, should first remove the pulley, the belt again after loaded on the belt wheel fixed on put pulley to the shaft. Double synchronous belt when installation should also pay attention to the following: 1, the pulley is to is parallel to the axis of completely, with tooth need and right Angle to the synchronous belt running direction. 2, can not use tools to synchronous belt to pry into the pulley, lest damage tensile layer. 3, be sure to fixed pulley bearing, center distance to avoid vibration. 4, the synchronous belt must not be prolonged storage, abnormal bending should be kept in the shade. Synchronous belt and synchronous belt wheels of maintenance ( 1) Synchronous belt transmission should not fold twist and a sharp bend, synchronization of the synchronous belt zui small bending diameter D as shown in figure 2, table 2. ( 2) In the process of storage and transportation, avoid direct sunlight, rain and snow shower; Prevent and acid, halide, affect the performance of the product material such as organic solvent, water vapor. ( 3) Room temperature storage, temperature for - commonly 20 ~ 50; And away from heat source at least one meter away. ( 4) Stored to prevent bear too much weight during deformation, shall not fold a pile, the synchronous belt must not be directly on the ground and should be synchronous belt hanging on a shelf or neatly on the shelf. Information: double synchronous belt rubber double synchronous belt at http://www. lilainuo。 com