Rubber synchronous belt at http://www. lilainuo。 com/products- 细节。 asp吗? Cpid = 145 installation method: installing a rubber synchronous belt, if the center distance of two pulleys can be moved, need to shorten the belt wheel center distance, installed after rubber synchronous belt, again to reset the center distance. If there is tension wheel, to relax the tension wheel, then install synchronous belt, tension wheel on reload. When the synchronous belt pulley jacket, bear in mind that don't too hard and hard or with a screwdriver to pry synchronous belt, in order to prevent the synchronous belt in the tensile layer produces imperceptible break phenomenon appearance. Good design synchronous belt pulley, zui chooses the structure of the two shafts can be closer to each other, if the structure does not allow, zui to synchronous belt and pulley with loaded on the corresponding shaft. Proper initial tension control.