Triangle prior to installation, if the layout of the two axial spacing can be adjusted, we should shorten the distance between first, good adhesive tape and then adjust the spacing as needed, if the two axial spacing is no adjustment, can be a triangle set into the first round of the tank, and then change another pulley, the triangle adhesive tape, using the same method with a set of triangle tape of it. Don't use something hard to pry when installation, hard to drag on triangle, avoid triangle tape elongation too loose or too tight. In case when installing pulley groove, two on the belt wheel in the middle of the alignment is necessary, so that it will form a triangle tape unilateral operation, serious wear and tear, drop triangle belt length. Elastic for triangle tape firmness often view the adjustment is necessary, make it conform to the requirements. Triangle is installed to install check, after hand in each of the tape should be used when looking at middle, 2 kg straight pressure, subsidence is ( 20 - - 30) Millimeter advisable, otherwise will be adjusted in time, want to choose the triangle rule type, adhesive tape, and demand for each group of triangle belt tightness, together to avoid the old and new mixed or cut the root number, if uneven, old and new triangle will make old triangle doesn't work, thus affect the power transfer and decrease the time of the triangle.