Transmitte triangle and aftercare transmission device how to install?

Installation of transmitte v-belts and aftercare transmission device has the following points: 1, move the motor belt enough to destroy, to easily remove the belt. Absolutely do not use equipment lever belt. 2, remove the old belt, search whether there is a very wear. Wear too perhaps means transmission plan or aftercare exist on the topic. 3, choose match belt replacement. 4, clean the belt and pulley: cloth should be stained with a little less volatile liquid to wipe, don't soak in purificant or exercise purificant scrub belt, do not use sandpaper to clean or scraping the belt with powerful object. Belt before installation to exercise need to keep dry. 5, search the pulley to see if there is crack or wear and tear, relatively modest pace is the exercise of gates groove measuring tool to search. If you wear too much, you may need to change the pulley. 6, search the pulley is unified in the plane. 7, search other transmission parts, such as environment, such as symmetry, durability and lubrication of the bearing. 8, deal with the exercise of multiple belt transmission device, you need a change all the belt. If multiple belt transmission device to change only one belt, the new change of the belt may be elastic, but the rest of the old belt is too loose, power large departments may only seriously by the new belt, the new belt premature failure. 9, tighten transmission center distance, turn a few circle driving wheel with the hand, the exercise of belt tension measurement instrument to search proper tension. 10, according to delimit the motor torque tighten mounting bolts. 11, and changing the guard. 12, proposed to adopt test run. The measures for startup drive, running in full load environment then curb mediation to the Lord, search and tension values. Belt under full load operation can make the belt and wheel groove completely consistent. If there is may make the belt running 24 hours a day, should run for at least an hour. Test run measures can engrave tide reset back tension. 13, the commissioning process should be fine mi monitoring operation environment, to examine whether there is a very vibration, if there is a very fine listen to noise. Zui is good after running for a period of time off inflexible, search of bearing and motor fever; If you think it's too hot to the touch, may be the belt is too tight, or bearing exactly to say, or lubrication is not correct. 14, for synchronous belt, running in the process of destruction, to unnecessary tension from mediation is the same as usual, but we offer starting device and investigate circulation function, to examine whether there is a very vibration, if there is a very fine listen to noise. Zui luckily run off after a period of time is inflexible, search the bearing and the status of the motor of fever; If you think it's too hot to the touch, may be the belt is too tight, or bearing exactly to say, or lubrication is not correct. This article by the triangle original, reproduced please indicate the copyright: http://www. lilainuo。 com