What are PVC synchronous belt running deviation adjustment method

WechatIMG111. Jpeg if our conveyor belt in the use cases of easily will affect our normal work efficiency, combined with its own wear increased, to a certain extent, reduce the service life of the conveyor belt. So once we found in PVC synchronization under the condition of conveyor belt running deviation is need to stop for repair in time. Below small make up to introduce for everybody.

PVC synchronous belt running deviation adjustment solutions

1, adjust the roller bracket if always to one side when conveyor belt in no-load running deviation, you should run to slant side roller stents moved forward 1 - along the conveyor belt running direction 2 cm, or to the other side roller support proper heightening.

2, the adjustment method of the tensioning mechanism operation of the conveyor belt, if in the case of no-load and overloading are from the same side wandering, shows firmness on either side of the conveyor belt is not the same, shall be according to the rule of running tight not loose, the adjustment of the tensioning mechanism screw or weight. If about conveyor belt running deviation and has no fixed direction, shows a conveyor belt is flabby, should adjust tension mechanism.

3, adjust the conveyer belt if worn edges or conveyor belt conveyor belt joint is not parallel, will make both sides of the conveyer belt tension appear inconsistent. Should rebuild or replace the conveyor belt.

4, adjusting drum if under the condition of conveyor belt running deviation in drum, shows the level of the installation of the roller is owe, roller axial moving, or roller in the front end at the end of the last. At this point, should be corrected the levelness of the drum and parallel degree, etc.

5, remove glue content if stuck on roller, roller of local materials, will make its diameter increasing, which leads to the severe conveyer belt tension, wandering. Should be timely clean the adhesive materials.

6, installation limit if the conveyor roller method always wandering to one side, can be in running deviation limit vertical roll mounted on side of the frame. So, on the one hand is to reset the conveyor belt to force, on the other hand vertical roll is can decrease the tension of the conveyor belt running deviation side, so that the conveyor belt to move to the other side.

7, adjust the gravity method if not running deviation when the conveyor belt in the light, and always to one side when overloaded running deviation, that was in the partial load conveyor belt. Should be adjusted after hopper or transfer the position of the machine, the conveyor belt, are to keep them from wandering.

8, install automatic correction in conveyor installed on an automatic correction device, in order to prevent the conveyor belt running deviation.

9, install, adjust if install two groups in the conveyor roller method automatically self-aligning roller, which can automatically correct the conveyor belt running deviation phenomenon. When the conveyor belt running deviation on either side and small gear roller friction, should make the side of the bracket along the conveyor belt running direction forward, on the other side is relatively backward, the conveyor belt will move towards moving block after roller side, until the return to normal position.

the above is the small make up this issue to bring about PVC synchronous belt running deviation adjustment solution is introduced, I believe you after see our article also have some knowledge of its contents, our conveyor belt in the event of a case of also handled timely, otherwise may affect the use of late.